Home > Product > Thermal conductive double-sided adhesive

Thermal Conductive Double-Sided Adhesive

Category：Thermal conductive double-sided adhesive

For dimensional stability and improved handling with ease of die cutting and laminating. The high adhesion adhesive provides excellent adhesion to a variety of surfaces. Good resistance to temperature, thermal conductivity , insulation properties

Details

Glass fiber thermal conductive tape series

Application Ideas：

For LED lamp belt, electronic components and other components of the bonding and cooling.

Construction：

Item	NDF 020100	NDF 053150	NDF 010200	NDF 010250	NDF 010300	NDF 010350	NDF 010380	NDF 010400	NDF 010500	NDF 010600	NDF 010700
Total thickness	0.10	0.15	0.20	0.250	0.30	0.35	0.38	0.40	0.50	0.60	0.70
Size(width X length)	1050mm50M/100M（T0.10-T0.25）；1000mm50M （≥T0.30）;1240mm*50M/100M(T0.10-T0.20)
Substrate thickness	T0.02（T0.10）/ T0.053（T0.15~T0.20）/T0.10（≥T0.25）
Adhesive	Acrylic
colour	White/Black
Tube core	3.0”（76.0）
Release paper/film	white paper（T0.125）or Blue / redfilm（T0.075）

Typical Physical Properties and Performance Characteristics：

Note: the following technical information and data are subject to national or international or industry standard test results for customer selection or acceptance of reference.

Application Techniques：

User is responsible for determining whether the HM product is fit for a particular purpose and suitable for user's method of application. Please remember that many factors can affect the use and performance.

The materials to be bonded with the product, the surface preparation of those materials, the product selected for use, the conditions in which the product is used.

Relationship between temperature, pressure and infiltration area：

Conclusion: in order to obtain more than 90% of sufficient infiltration, the required operating temperature above 15 degrees Celsius and more than 5 kg of pressure.

1.surface treatment

In order to get the best adhesion, the paste surface must be clean, dry and smooth.

Clean the oil and dust on the bonding surface with isopropanol, gasoline, toluene, etc.. Belong to rubber or resin bonding surface, must be coated with rubber (treatment agent).

Note: be sure to do the surface cleaning before bonding!when using solvents, please read and follow the company's precautions.

2.parts installation

First install the parts, check the position, then peel off the paper and install the parts. Remember not to touch the surface If the bonding surface is clean, the parts can be removed and re bonded (not suitable for the surface of the base).

Parts to be installed in the correct position, positioning errors can lead to tape off.

Less than 15 degrees shall be heated by a heater part and the paste surface (the best range of 21-38).

3.pressure

When attaching to the paste, press 2-3Kg to paste the area. If the residual air between the adhesive tape and the adhesive surface results in the decrease of the adhesive force, sufficient pressure should be exerted.

Limitation ofRemedies and Liability：

If theNDproduct is proved to be defective, The exclusive remedy, at ND'S option, shall be to refundthe purchase p rice of or to repair or rplace the defective HMproduct. NDshall not otherwise be liablefor loss or damages, wheth er direct, indirect,special, incidental, or consequential, regardless of thelegal theory asserted, including, but not li mitedto, contract,negligence, warranty, or strict liability.